use crate::svd::{create_bit_range, create_field, create_register, create_register_properties};
use crate::Result;
/// Creates the Shadow Break Control Register.
pub fn create() -> Result<svd::RegisterCluster> {
Ok(svd::RegisterCluster::Register(
create_register(
"sbcr",
"Shadow Break Control Register: This register is only valid when the DW_apb_uart is configured to have additional shadow registers implemented (SHADOW == YES). If shadow registers are not implemented, this register does not exist and reading from this register address returns zero.",
0x90,
create_register_properties(32, 0)?,
Some(&[
create_field(
"sbcr",
"Shadow Break Control Bit. This is a shadow register for the Break bit (LCR[6]), this can be used to remove the burden of having to performing a read modify write on the LCR. This is used to cause a break condition to be transmitted to the receiving device. If set to one the serial output is forced to the spacing (logic 0) state. When not in Loopback Mode, as determined by MCR[4], the sout line is forced low until the Break bit is cleared. If SIR_MODE == Enabled and active (MCR[6] = 1) the sir_out_n line is continuously pulsed. When in Loopback Mode, the break condition is internally looped back to the receiver.",
create_bit_range("[0:0]")?,
svd::Access::ReadWrite,
None,
)?
]),
None,
)?
))
}