esp32c3-hal 0.15.1

//! GPIO interrupt
//!
//! This prints "Interrupt" when the boot button is pressed.
//! It also blinks an LED like the blinky example.

#![no_std]
#![no_main]

use core::cell::RefCell;

use critical_section::Mutex;
use esp32c3_hal::{
    clock::ClockControl,
    gpio::{Event, Gpio9, Input, PullDown, IO},
    interrupt,
    peripherals::{self, Peripherals},
    prelude::*,
    Delay,
};
use esp_backtrace as _;

static BUTTON: Mutex<RefCell<Option<Gpio9<Input<PullDown>>>>> = Mutex::new(RefCell::new(None));

#[entry]
fn main() -> ! {
    let peripherals = Peripherals::take();
    let system = peripherals.SYSTEM.split();
    let clocks = ClockControl::boot_defaults(system.clock_control).freeze();

    // Set GPIO5 as an output
    let io = IO::new(peripherals.GPIO, peripherals.IO_MUX);
    let mut led = io.pins.gpio5.into_push_pull_output();

    // Set GPIO9 as an input
    let mut button = io.pins.gpio9.into_pull_down_input();
    button.listen(Event::FallingEdge);

    critical_section::with(|cs| BUTTON.borrow_ref_mut(cs).replace(button));

    interrupt::enable(peripherals::Interrupt::GPIO, interrupt::Priority::Priority3).unwrap();

    let mut delay = Delay::new(&clocks);
    loop {
        led.toggle().unwrap();
        delay.delay_ms(500u32);
    }
}

#[interrupt]
fn GPIO() {
    critical_section::with(|cs| {
        esp_println::println!("GPIO interrupt");
        BUTTON
            .borrow_ref_mut(cs)
            .as_mut()
            .unwrap()
            .clear_interrupt();
    });
}