esp32c3-hal 0.15.1

HAL for ESP32-C3 microcontrollers
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67

//! This shows how to configure UART
//! You can short the TX and RX pin and see it reads what was written.
//! Additionally you can connect a logic analzyer to TX and see how the changes
//! of the configuration change the output signal.
//!
//! The following wiring is assumed:
//! - TX => GPIO1
//! - RX => GPIO2

#![no_std]
#![no_main]

use esp32c3_hal::{
    clock::ClockControl,
    peripherals::Peripherals,
    prelude::*,
    timer::TimerGroup,
    uart::{
        config::{Config, DataBits, Parity, StopBits},
        TxRxPins,
    },
    Uart,
    IO,
};
use esp_backtrace as _;
use esp_println::println;
use nb::block;

#[entry]
fn main() -> ! {
    let peripherals = Peripherals::take();
    let system = peripherals.SYSTEM.split();
    let clocks = ClockControl::boot_defaults(system.clock_control).freeze();

    let timer_group0 = TimerGroup::new(peripherals.TIMG0, &clocks);
    let mut timer0 = timer_group0.timer0;

    let config = Config {
        baudrate: 115200,
        data_bits: DataBits::DataBits8,
        parity: Parity::ParityNone,
        stop_bits: StopBits::STOP1,
    };

    let io = IO::new(peripherals.GPIO, peripherals.IO_MUX);
    let pins = TxRxPins::new_tx_rx(
        io.pins.gpio1.into_push_pull_output(),
        io.pins.gpio2.into_floating_input(),
    );

    let mut serial1 = Uart::new_with_config(peripherals.UART1, config, Some(pins), &clocks);

    timer0.start(250u64.millis());

    println!("Start");
    loop {
        serial1.write(0x42).ok();
        let read = block!(serial1.read());

        match read {
            Ok(read) => println!("Read 0x{:02x}", read),
            Err(err) => println!("Error {:?}", err),
        }

        block!(timer0.wait()).unwrap();
    }
}