pub enum Sd {
PA1(PA1<Alternate<5, PushPull>>),
PE6(PE6<Alternate<5, PushPull>>),
PE14(PE14<Alternate<5, PushPull>>),
}
Variants§
PA1(PA1<Alternate<5, PushPull>>)
PE6(PE6<Alternate<5, PushPull>>)
PE14(PE14<Alternate<5, PushPull>>)
Trait Implementations§
source§impl ExtiPin for Sd
impl ExtiPin for Sd
source§fn make_interrupt_source(&mut self, _syscfg: &mut SysCfg)
fn make_interrupt_source(&mut self, _syscfg: &mut SysCfg)
Make corresponding EXTI line sensitive to this pin
source§fn trigger_on_edge(&mut self, _exti: &mut EXTI, _level: Edge)
fn trigger_on_edge(&mut self, _exti: &mut EXTI, _level: Edge)
Generate interrupt on rising edge, falling edge or both
source§fn enable_interrupt(&mut self, _exti: &mut EXTI)
fn enable_interrupt(&mut self, _exti: &mut EXTI)
Enable external interrupts from this pin.
source§fn disable_interrupt(&mut self, _exti: &mut EXTI)
fn disable_interrupt(&mut self, _exti: &mut EXTI)
Disable external interrupts from this pin
source§fn clear_interrupt_pending_bit(&mut self)
fn clear_interrupt_pending_bit(&mut self)
Clear the interrupt pending bit for this pin
source§fn check_interrupt(&self) -> bool
fn check_interrupt(&self) -> bool
Reads the interrupt pending bit for this pin
source§impl PinPull for Sd
impl PinPull for Sd
source§fn set_internal_resistor(&mut self, _pull: Pull)
fn set_internal_resistor(&mut self, _pull: Pull)
Set the internal pull-up and pull-down resistor
fn internal_resistor(self, resistor: Pull) -> Self
Auto Trait Implementations§
impl RefUnwindSafe for Sd
impl Send for Sd
impl Sync for Sd
impl Unpin for Sd
impl UnwindSafe for Sd
Blanket Implementations§
source§impl<T> BorrowMut<T> for Twhere
T: ?Sized,
impl<T> BorrowMut<T> for Twhere
T: ?Sized,
source§fn borrow_mut(&mut self) -> &mut T
fn borrow_mut(&mut self) -> &mut T
Mutably borrows from an owned value. Read more