Struct stm32_hal2::pac::pwr::cr3::R

pub struct R(_);

Register CR3 reader

Implementations

impl R

pub fn bypass(&self) -> BitReaderRaw<bool>

Bit 0 - Power management unit bypass

pub fn ldoen(&self) -> BitReaderRaw<bool>

Bit 1 - Low drop-out regulator enable

pub fn sden(&self) -> BitReaderRaw<bool>

Bit 2 - SD converter Enable

pub fn vbe(&self) -> BitReaderRaw<bool>

Bit 8 - VBAT charging enable

pub fn vbrs(&self) -> BitReaderRaw<bool>

Bit 9 - VBAT charging resistor selection

pub fn usbregen(&self) -> BitReaderRaw<bool>

Bit 25 - USB regulator enable.

pub fn usb33rdy(&self) -> BitReaderRaw<bool>

Bit 26 - USB supply ready.

pub fn sdexthp(&self) -> BitReaderRaw<bool>

Bit 3 - SMPS step-down converter forced ON and in High Power MR mode

pub fn sdlevel(&self) -> FieldReaderRaw<u8, u8>

Bits 4:5 - SMPS step-down converter voltage output level selection

pub fn sdextrdy(&self) -> BitReaderRaw<bool>

Bit 16 - SMPS step-down converter external supply ready

Methods from Deref<Target = R<CR3_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CR3_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<CR3_SPEC>> for R

fn from(reader: R<CR3_SPEC>) -> R

Converts to this type from the input type.