pub struct R(_);
Expand description
Register TIMEOUTR
reader
Implementations
sourceimpl R
impl R
sourcepub fn timeouta(&self) -> FieldReaderRaw<u16, u16>
pub fn timeouta(&self) -> FieldReaderRaw<u16, u16>
Bits 0:11 - Bus Timeout A This field is used to configure: The SCL low timeout condition tTIMEOUT when TIDLE=0 tTIMEOUT= (TIMEOUTA+1) x 2048 x tI2CCLK The bus idle condition (both SCL and SDA high) when TIDLE=1 tIDLE= (TIMEOUTA+1) x 4 x tI2CCLK Note: These bits can be written only when TIMOUTEN=0.
sourcepub fn tidle(&self) -> BitReaderRaw<TIDLE_A>
pub fn tidle(&self) -> BitReaderRaw<TIDLE_A>
Bit 12 - Idle clock timeout detection Note: This bit can be written only when TIMOUTEN=0.
sourcepub fn timouten(&self) -> BitReaderRaw<TIMOUTEN_A>
pub fn timouten(&self) -> BitReaderRaw<TIMOUTEN_A>
Bit 15 - Clock timeout enable
sourcepub fn timeoutb(&self) -> FieldReaderRaw<u16, u16>
pub fn timeoutb(&self) -> FieldReaderRaw<u16, u16>
Bits 16:27 - Bus timeout B This field is used to configure the cumulative clock extension timeout: In master mode, the master cumulative clock low extend time (tLOW:MEXT) is detected In slave mode, the slave cumulative clock low extend time (tLOW:SEXT) is detected tLOW:EXT= (TIMEOUTB+1) x 2048 x tI2CCLK Note: These bits can be written only when TEXTEN=0.
Methods from Deref<Target = R<TIMEOUTR_SPEC>>
sourcepub fn bits(&self) -> <REG as RegisterSpec>::Ux
pub fn bits(&self) -> <REG as RegisterSpec>::Ux
Reads raw bits from register.