Enum Mstdma 

pub enum Mstdma {
    Disabled = 0,
    Enabled = 1,
}

Master DMA enable. Data operations of the I2C can be performed with DMA. Protocol type operations such as Start, address, Stop, and address match must always be done with software, typically via an interrupt. Address acknowledgement must also be done by software except when the I2C is configured to be HSCAPABLE (and address acknowledgement is handled entirely by hardware) or when Automatic Operation is enabled. When a DMA data transfer is complete, MSTDMA must be cleared prior to beginning the next operation, typically a Start or Stop.This bit is read/write.

Value on reset: 0

Variants

Disabled = 0

0: Disable. No DMA requests are generated for master operation.

Enabled = 1

1: Enable. A DMA request is generated for I2C master data operations. When this I2C master is generating Acknowledge bits in Master Receiver mode, the acknowledge is generated automatically.

Trait Implementations

impl Clone for Mstdma

fn clone(&self) -> Mstdma

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for Mstdma

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<Mstdma> for bool

fn from(variant: Mstdma) -> Self

Converts to this type from the input type.

impl PartialEq for Mstdma

fn eq(&self, other: &Mstdma) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Mstdma

impl Eq for Mstdma

impl StructuralPartialEq for Mstdma