Struct esp32::uart0::conf1::R

pub struct R(_);

Register CONF1 reader

Implementations

impl R

pub fn rxfifo_full_thrhd(&self) -> RXFIFO_FULL_THRHD_R

Bits 0:6 - When receiver receives more data than its threshold value.receiver will produce rxfifo_full_int_raw interrupt.the threshold value is (rx_flow_thrhd_h3 rxfifo_full_thrhd).

pub fn txfifo_empty_thrhd(&self) -> TXFIFO_EMPTY_THRHD_R

Bits 8:14 - when the data amount in transmitter fifo is less than its threshold value. it will produce txfifo_empty_int_raw interrupt. the threshold value is (tx_mem_empty_thrhd txfifo_empty_thrhd)

pub fn rx_flow_thrhd(&self) -> RX_FLOW_THRHD_R

Bits 16:22 - when receiver receives more data than its threshold value. receiver produce signal to tell the transmitter stop transferring data. the threshold value is (rx_flow_thrhd_h3 rx_flow_thrhd).

pub fn rx_flow_en(&self) -> RX_FLOW_EN_R

Bit 23 - This is the flow enable bit for uart receiver. 1:choose software flow control with configuring sw_rts signal

pub fn rx_tout_thrhd(&self) -> RX_TOUT_THRHD_R

Bits 24:30 - This register is used to configure the timeout value for uart receiver receiving a byte.

pub fn rx_tout_en(&self) -> RX_TOUT_EN_R

Bit 31 - This is the enble bit for uart receiver’s timeout function.

Methods from Deref<Target = R<CONF1_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CONF1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CONF1_SPEC>> for R

fn from(reader: R<CONF1_SPEC>) -> Self

Converts to this type from the input type.