Module esp32::uart0::conf1

Structs

CONF1_SPEC

This register you can read, write_with_zero, reset, write, modify. See API.

R

Register CONF1 reader

W

Register CONF1 writer

Type Definitions

RXFIFO_FULL_THRHD_R

Field RXFIFO_FULL_THRHD reader - When receiver receives more data than its threshold value.receiver will produce rxfifo_full_int_raw interrupt.the threshold value is (rx_flow_thrhd_h3 rxfifo_full_thrhd).

RXFIFO_FULL_THRHD_W

Field RXFIFO_FULL_THRHD writer - When receiver receives more data than its threshold value.receiver will produce rxfifo_full_int_raw interrupt.the threshold value is (rx_flow_thrhd_h3 rxfifo_full_thrhd).

RX_FLOW_EN_R

Field RX_FLOW_EN reader - This is the flow enable bit for uart receiver. 1:choose software flow control with configuring sw_rts signal

RX_FLOW_EN_W

Field RX_FLOW_EN writer - This is the flow enable bit for uart receiver. 1:choose software flow control with configuring sw_rts signal

RX_FLOW_THRHD_R

Field RX_FLOW_THRHD reader - when receiver receives more data than its threshold value. receiver produce signal to tell the transmitter stop transferring data. the threshold value is (rx_flow_thrhd_h3 rx_flow_thrhd).

RX_FLOW_THRHD_W

Field RX_FLOW_THRHD writer - when receiver receives more data than its threshold value. receiver produce signal to tell the transmitter stop transferring data. the threshold value is (rx_flow_thrhd_h3 rx_flow_thrhd).

RX_TOUT_EN_R

Field RX_TOUT_EN reader - This is the enble bit for uart receiver’s timeout function.

RX_TOUT_EN_W

Field RX_TOUT_EN writer - This is the enble bit for uart receiver’s timeout function.

RX_TOUT_THRHD_R

Field RX_TOUT_THRHD reader - This register is used to configure the timeout value for uart receiver receiving a byte.

RX_TOUT_THRHD_W

Field RX_TOUT_THRHD writer - This register is used to configure the timeout value for uart receiver receiving a byte.

TXFIFO_EMPTY_THRHD_R

Field TXFIFO_EMPTY_THRHD reader - when the data amount in transmitter fifo is less than its threshold value. it will produce txfifo_empty_int_raw interrupt. the threshold value is (tx_mem_empty_thrhd txfifo_empty_thrhd)

TXFIFO_EMPTY_THRHD_W

Field TXFIFO_EMPTY_THRHD writer - when the data amount in transmitter fifo is less than its threshold value. it will produce txfifo_empty_int_raw interrupt. the threshold value is (tx_mem_empty_thrhd txfifo_empty_thrhd)