stm32f1xx-hal 0.10.0

//! ADC interface DMA RX transfer test

#![allow(clippy::empty_loop)]
#![no_main]
#![no_std]

use panic_halt as _;

use cortex_m::{asm, singleton};

use cortex_m_rt::entry;
use stm32f1xx_hal::{adc, pac, prelude::*};

#[entry]
fn main() -> ! {
    // Acquire peripherals
    let p = pac::Peripherals::take().unwrap();
    let mut flash = p.FLASH.constrain();
    let rcc = p.RCC.constrain();

    // Configure ADC clocks
    // Default value is the slowest possible ADC clock: PCLK2 / 8. Meanwhile ADC
    // clock is configurable. So its frequency may be tweaked to meet certain
    // practical needs. User specified value is be approximated using supported
    // prescaler values 2/4/6/8.
    let clocks = rcc.cfgr.adcclk(2.MHz()).freeze(&mut flash.acr);

    let dma_ch1 = p.DMA1.split().1;

    // Setup ADC
    let adc1 = adc::Adc::adc1(p.ADC1, clocks);

    // Setup GPIOA
    let mut gpioa = p.GPIOA.split();

    // Configure pa0 as an analog input
    let adc_ch0 = gpioa.pa0.into_analog(&mut gpioa.crl);

    let adc_dma = adc1.with_dma(adc_ch0, dma_ch1);
    let buf = singleton!(: [u16; 8] = [0; 8]).unwrap();

    // The read method consumes the buf and self, starts the adc and dma transfer and returns a
    // RxDma struct. The wait method consumes the RxDma struct, waits for the whole transfer to be
    // completed and then returns the updated buf and underlying adc_dma struct. For non blocking,
    // one can call the is_done method of RxDma and only call wait after that method returns true.
    let (_buf, adc_dma) = adc_dma.read(buf).wait();
    asm::bkpt();

    // Consumes the AdcDma struct, restores adc configuration to previous state and returns the
    // Adc struct in normal mode.
    let (_adc1, _adc_ch0, _dma_ch1) = adc_dma.split();
    asm::bkpt();

    loop {}
}