sh1106 0.5.0

//! Draw a 1 bit per pixel black and white image. On a 128x64 sh1106 display over I2C.
//!
//! Image was created with ImageMagick:
//!
//! ```bash
//! convert rust.png -depth 1 gray:rust.raw
//! ```
//!
//! This example is for the STM32F103 "Blue Pill" board using I2C1.
//!
//! Wiring connections are as follows for a CRIUS-branded display:
//!
//! ```
//!      Display -> Blue Pill
//! (black)  GND -> GND
//! (red)    +5V -> VCC
//! (yellow) SDA -> PB9
//! (green)  SCL -> PB8
//! ```
//!
//! Run on a Blue Pill with `cargo run --example image`.

#![no_std]
#![no_main]

use cortex_m_rt::{entry, exception, ExceptionFrame};
use embedded_graphics::{
    image::{Image, ImageRawLE},
    pixelcolor::BinaryColor,
    prelude::*,
};
use panic_semihosting as _;
use sh1106::{prelude::*, Builder};
use stm32f1xx_hal::{
    i2c::{BlockingI2c, DutyCycle, Mode},
    prelude::*,
    stm32,
};

#[entry]
fn main() -> ! {
    let dp = stm32::Peripherals::take().unwrap();

    let mut flash = dp.FLASH.constrain();
    let mut rcc = dp.RCC.constrain();

    let clocks = rcc.cfgr.freeze(&mut flash.acr);

    let mut afio = dp.AFIO.constrain(&mut rcc.apb2);

    let mut gpiob = dp.GPIOB.split(&mut rcc.apb2);

    let scl = gpiob.pb8.into_alternate_open_drain(&mut gpiob.crh);
    let sda = gpiob.pb9.into_alternate_open_drain(&mut gpiob.crh);

    let i2c = BlockingI2c::i2c1(
        dp.I2C1,
        (scl, sda),
        &mut afio.mapr,
        Mode::Fast {
            frequency: 100.khz().into(),
            duty_cycle: DutyCycle::Ratio2to1,
        },
        clocks,
        &mut rcc.apb1,
        1000,
        10,
        1000,
        1000,
    );

    let mut display: GraphicsMode<_> = Builder::new().connect_i2c(i2c).into();

    display.init().unwrap();
    display.flush().unwrap();

    let im: ImageRawLE<BinaryColor> = ImageRawLE::new(include_bytes!("./rust.raw"), 64);

    Image::new(&im, Point::new(32, 0))
        .draw(&mut display)
        .unwrap();

    display.flush().unwrap();

    loop {}
}

#[exception]
fn HardFault(ef: &ExceptionFrame) -> ! {
    panic!("{:#?}", ef);
}