esp32-hal 0.18.1

//! This shows how to continously receive data via I2S
//!
//! Pins used
//! BCLK    GPIO12
//! WS      GPIO13
//! DIN     GPIO14
//!
//! Without an additional I2S source device you can connect 3V3 or GND to DIN to
//! read 0 or 0xFF or connect DIN to WS to read two different values
//!
//! You can also inspect the MCLK, BCLK and WS with a logic analyzer

#![no_std]
#![no_main]

use esp32_hal::{
    clock::ClockControl,
    dma::DmaPriority,
    dma_buffers,
    i2s::{DataFormat, I2s, I2sReadDma, Standard},
    pdma::Dma,
    peripherals::Peripherals,
    prelude::*,
    IO,
};
use esp_backtrace as _;
use esp_println::println;

#[entry]
fn main() -> ! {
    let peripherals = Peripherals::take();
    let system = peripherals.SYSTEM.split();
    let clocks = ClockControl::boot_defaults(system.clock_control).freeze();

    let io = IO::new(peripherals.GPIO, peripherals.IO_MUX);

    let dma = Dma::new(system.dma);
    let dma_channel = dma.i2s0channel;

    let (_, mut tx_descriptors, rx_buffer, mut rx_descriptors) = dma_buffers!(0, 4092 * 4);

    let i2s = I2s::new(
        peripherals.I2S0,
        Standard::Philips,
        DataFormat::Data16Channel16,
        44100u32.Hz(),
        dma_channel.configure(
            false,
            &mut tx_descriptors,
            &mut rx_descriptors,
            DmaPriority::Priority0,
        ),
        &clocks,
    );

    let i2s_rx = i2s
        .i2s_rx
        .with_bclk(io.pins.gpio12)
        .with_ws(io.pins.gpio13)
        .with_din(io.pins.gpio14)
        .build();

    let buffer = rx_buffer;

    let mut transfer = i2s_rx.read_dma_circular(buffer).unwrap();
    println!("Started transfer");

    loop {
        let avail = transfer.available();

        if avail > 0 {
            let mut rcv = [0u8; 5000];
            transfer.pop(&mut rcv[..avail]).unwrap();
            println!("Received {:x?}...", &rcv[..30]);
        }
    }
}