Enum STARTW 

pub enum STARTW {
    Start = 1,
}

Start generation This bit is set by software, and cleared by hardware after the Start followed by the address sequence is sent, by an arbitration loss, by an address matched in slave mode, by a timeout error detection, or when PE = 0. If the I2C is already in master mode with AUTOEND = 0, setting this bit generates a Repeated Start condition when RELOAD=0, after the end of the NBYTES transfer. Otherwise setting this bit generates a START condition once the bus is free. Note: Writing ‘0’ to this bit has no effect. The START bit can be set even if the bus is BUSY or I2C is in slave mode. This bit has no effect when RELOAD is set.

Value on reset: 0

Variants

Start = 1

1: Restart/Start generation

Trait Implementations

impl Clone for STARTW

fn clone(&self) -> STARTW

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for STARTW

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Format for STARTW

fn format(&self, f: Formatter<'_>)

Writes the defmt representation of self to fmt.

impl From<STARTW> for bool

fn from(variant: STARTW) -> Self

Converts to this type from the input type.

impl PartialEq for STARTW

fn eq(&self, other: &STARTW) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for STARTW

impl Eq for STARTW

impl StructuralPartialEq for STARTW