Enum stm32g0::stm32g0c1::adc::isr::CCRDY_AW

pub enum CCRDY_AW {
    Clear,
}

Channel Configuration Ready flag This flag bit is set by hardware when the channel configuration is applied after programming to ADC_CHSELR register or changing CHSELRMOD or SCANDIR. It is cleared by software by programming it to it. Note: When the software configures the channels (by programming ADC_CHSELR or changing CHSELRMOD or SCANDIR), it must wait until the CCRDY flag rises before configuring again or starting conversions, otherwise the new configuration (or the START bit) is ignored. Once the flag is asserted, if the software needs to configure again the channels, it must clear the CCRDY flag before proceeding with a new configuration.

Value on reset: 0

Variants

Clear

1: Clear the channel configuration flag

Trait Implementations

impl Clone for CCRDY_AW

fn clone(&self) -> CCRDY_AW

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for CCRDY_AW

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<CCRDY_AW> for bool

fn from(variant: CCRDY_AW) -> Self

Converts to this type from the input type.

impl PartialEq<CCRDY_AW> for CCRDY_AW

fn eq(&self, other: &CCRDY_AW) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=.

impl Copy for CCRDY_AW

impl StructuralPartialEq for CCRDY_AW