Struct stm32g0::stm32g0c1::aes::keyr0::R

pub struct R(_);

Register KEYR0 reader

Implementations

impl R

pub fn key(&self) -> KEY_R

Bits 0:31 - Cryptographic key, bits [31:0] This bitfield contains the bits [31:0] of the AES encryption or decryption key, depending on the operating mode: - In Mode 1 (encryption), Mode 2 (key derivation) and Mode 4 (key derivation then single decryption): the value to write into the bitfield is the encryption key. - In Mode 3 (decryption): the value to write into the bitfield is the encryption key to be derived before being used for decryption. After writing the encryption key into the bitfield, its reading before enabling AES returns the same value. Its reading after enabling AES and after the CCF flag is set returns the decryption key derived from the encryption key. Note: In mode 4 (key derivation then single decryption) the bitfield always contains the encryption key. The AES_KEYRx registers may be written only when KEYSIZE value is correct and when the AES peripheral is disabled (EN bit of the AES_CR register cleared). Note that, if, the key is directly loaded to AES_KEYRx registers (hence writes to key register is ignored and KEIF is set). Refer to for more details.

Methods from Deref<Target = R<KEYR0_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<KEYR0_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<KEYR0_SPEC>> for R

fn from(reader: R<KEYR0_SPEC>) -> Self

Performs the conversion.