Struct stm32g0::stm32g0b0::usart1::isr_fifo_enabled::TCBGT_R

pub struct TCBGT_R(_);

Field TCBGT reader - Transmission complete before guard time flag This bit is set when the last data written in the USART_TDR has been transmitted correctly out of the shift register. It is set by hardware in Smartcard mode, if the transmission of a frame containing data is complete and if the smartcard did not send back any NACK. An interrupt is generated if TCBGTIE = 1 in the USART_CR3 register. This bit is cleared by software, by writing 1 to the TCBGTCF in the USART_ICR register or by a write to the USART_TDR register. Note: If the USART does not support the Smartcard mode, this bit is reserved and kept at reset value. If the USART supports the Smartcard mode and the Smartcard mode is enabled, the TCBGT reset value is ’1’. Refer to on page 835.

Implementations

impl TCBGT_R

pub fn variant(&self) -> TCBGT_A

Get enumerated values variant

pub fn is_b_0x0(&self) -> bool

Checks if the value of the field is B_0X0

pub fn is_b_0x1(&self) -> bool

Checks if the value of the field is B_0X1

Methods from Deref<Target = FieldReader<bool, TCBGT_A>>

pub fn bits(&self) -> U

Reads raw bits from field.

pub fn bit(&self) -> bool

Value of the field as raw bits.

pub fn bit_is_clear(&self) -> bool

Returns true if the bit is clear (0).

pub fn bit_is_set(&self) -> bool

Returns true if the bit is set (1).

Trait Implementations

impl Deref for TCBGT_R

type Target = FieldReader<bool, TCBGT_A>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.