Struct stm32g0::stm32g0b0::usart1::isr_fifo_disabled::RTOF_R

pub struct RTOF_R(_);

Field RTOF reader - Receiver timeout This bit is set by hardware when the timeout value, programmed in the RTOR register has lapsed, without any communication. It is cleared by software, writing 1 to the RTOCF bit in the USART_ICR register. An interrupt is generated if RTOIEÂ =Â 1 in the USART_CR2 register. In Smartcard mode, the timeout corresponds to the CWT or BWT timings. Note: If a time equal to the value programmed in RTOR register separates 2 characters, RTOF is not set. If this time exceeds this value + 2 sample times (2/16 or 2/8, depending on the oversampling method), RTOF flag is set. The counter counts even if RE = 0 but RTOF is set only when RE = 1. If the timeout has already elapsed when RE is set, then RTOF is set. If the USART does not support the Receiver timeout feature, this bit is reserved and kept at reset value.

Implementations

impl RTOF_R

pub fn variant(&self) -> RTOF_A

Get enumerated values variant

pub fn is_b_0x0(&self) -> bool

Checks if the value of the field is B_0X0

pub fn is_b_0x1(&self) -> bool

Checks if the value of the field is B_0X1

Methods from Deref<Target = FieldReader<bool, RTOF_A>>

pub fn bits(&self) -> U

Reads raw bits from field.

pub fn bit(&self) -> bool

Value of the field as raw bits.

pub fn bit_is_clear(&self) -> bool

Returns true if the bit is clear (0).

pub fn bit_is_set(&self) -> bool

Returns true if the bit is set (1).

Trait Implementations

impl Deref for RTOF_R

type Target = FieldReader<bool, RTOF_A>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.