Type Definition stm32g0::stm32g081::usart1::cr2::R [−][src]
type R = R<u32, CR2>;
Reader of register CR2
Implementations
impl R
[src]
pub fn add4_7(&self) -> ADD4_7_R
[src]
Bits 28:31 - Address of the USART node
pub fn add0_3(&self) -> ADD0_3_R
[src]
Bits 24:27 - Address of the USART node
pub fn rtoen(&self) -> RTOEN_R
[src]
Bit 23 - Receiver timeout enable
pub fn abrmod(&self) -> ABRMOD_R
[src]
Bits 21:22 - Auto baud rate mode
pub fn abren(&self) -> ABREN_R
[src]
Bit 20 - Auto baud rate enable
pub fn msbfirst(&self) -> MSBFIRST_R
[src]
Bit 19 - Most significant bit first
pub fn tainv(&self) -> TAINV_R
[src]
Bit 18 - Binary data inversion
pub fn txinv(&self) -> TXINV_R
[src]
Bit 17 - TX pin active level inversion
pub fn rxinv(&self) -> RXINV_R
[src]
Bit 16 - RX pin active level inversion
pub fn swap(&self) -> SWAP_R
[src]
Bit 15 - Swap TX/RX pins
pub fn linen(&self) -> LINEN_R
[src]
Bit 14 - LIN mode enable
pub fn stop(&self) -> STOP_R
[src]
Bits 12:13 - STOP bits
pub fn clken(&self) -> CLKEN_R
[src]
Bit 11 - Clock enable
pub fn cpol(&self) -> CPOL_R
[src]
Bit 10 - Clock polarity
pub fn cpha(&self) -> CPHA_R
[src]
Bit 9 - Clock phase
pub fn lbcl(&self) -> LBCL_R
[src]
Bit 8 - Last bit clock pulse
pub fn lbdie(&self) -> LBDIE_R
[src]
Bit 6 - LIN break detection interrupt enable
pub fn lbdl(&self) -> LBDL_R
[src]
Bit 5 - LIN break detection length
pub fn addm7(&self) -> ADDM7_R
[src]
Bit 4 - 7-bit Address Detection/4-bit Address Detection
pub fn dis_nss(&self) -> DIS_NSS_R
[src]
Bit 3 - When the DSI_NSS bit is set, the NSS pin input will be ignored
pub fn slven(&self) -> SLVEN_R
[src]
Bit 0 - Synchronous Slave mode enable