Enum ADSTARTR

pub enum ADSTARTR {
    NotActive = 0,
    Active = 1,
}

ADC start conversion command This bit is set by software to start ADC conversion. Depending on the EXTEN [1:0] configuration bits, a conversion either starts immediately (software trigger configuration) or once a hardware trigger event occurs (hardware trigger configuration). It is cleared by hardware: In single conversion mode (CONT=0, DISCEN=0), when software trigger is selected (EXTEN=00): at the assertion of the end of Conversion Sequence (EOS) flag. In discontinuous conversion mode(CONT=0, DISCEN=1), when the software trigger is selected (EXTEN=00): at the assertion of the end of Conversion (EOC) flag. In all other cases: after the execution of the ADSTP command, at the same time as the ADSTP bit is cleared by hardware. Note: The software is allowed to set ADSTART only when ADEN=1 and ADDIS=0 (ADC is enabled and there is no pending request to disable the ADC). After writing to ADC_CHSELR register or changing CHSELRMOD or SCANDIRW, it is mandatory to wait until CCRDY flag is asserted before setting ADSTART, otherwise, the value written to ADSTART is ignored.

Value on reset: 0

Variants

NotActive = 0

0: No conversion ongoing

Active = 1

1: ADC operating and may be converting

Trait Implementations

impl Clone for ADSTARTR

fn clone(&self) -> ADSTARTR

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for ADSTARTR

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Format for ADSTARTR

fn format(&self, f: Formatter<'_>)

Writes the defmt representation of self to fmt.

impl From<ADSTARTR> for bool

fn from(variant: ADSTARTR) -> Self

Converts to this type from the input type.

impl PartialEq for ADSTARTR

fn eq(&self, other: &ADSTARTR) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for ADSTARTR

impl Eq for ADSTARTR

impl StructuralPartialEq for ADSTARTR