Enum CCRDYW

pub enum CCRDYW {
    Clear = 1,
}

Channel Configuration Ready flag This flag bit is set by hardware when the channel configuration is applied after programming to ADC_CHSELR register or changing CHSELRMOD or SCANDIR. It is cleared by software by programming it to it. Note: When the software configures the channels (by programming ADC_CHSELR or changing CHSELRMOD or SCANDIR), it must wait until the CCRDY flag rises before configuring again or starting conversions, otherwise the new configuration (or the START bit) is ignored. Once the flag is asserted, if the software needs to configure again the channels, it must clear the CCRDY flag before proceeding with a new configuration.

Value on reset: 0

Variants

Clear = 1

1: Clear the channel configuration flag

Trait Implementations

impl Clone for CCRDYW

fn clone(&self) -> CCRDYW

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for CCRDYW

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Format for CCRDYW

fn format(&self, f: Formatter<'_>)

Writes the defmt representation of self to fmt.

impl From<CCRDYW> for bool

fn from(variant: CCRDYW) -> Self

Converts to this type from the input type.

impl PartialEq for CCRDYW

fn eq(&self, other: &CCRDYW) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for CCRDYW

impl Eq for CCRDYW

impl StructuralPartialEq for CCRDYW