Struct NVIC

Source

pub struct NVIC { /* private fields */ }

Expand description

Nested Vector Interrupt Controller

Implementations§

Source §

impl NVIC

Source

pub fn request(&mut self, interrupt: I)
where I: Nr,

Request an IRQ in software

Writing a value to the INTID field is the same as manually pending an interrupt by setting the corresponding interrupt bit in an Interrupt Set Pending Register. This is similar to set_pending.

This method is not available on ARMv6-M chips.

Source

pub fn clear_pending(&mut self, interrupt: I)
where I: Nr,

👎Deprecated since 0.5.8: Use NVIC::unpend

Clears interrupt’s pending state

Source

pub fn mask(interrupt: I)
where I: Nr,

Disables interrupt

Source

pub unsafe fn unmask(interrupt: I)
where I: Nr,

Enables interrupt

This function is unsafe because it can break mask-based critical sections

Source

pub fn disable(&mut self, interrupt: I)
where I: Nr,

👎Deprecated since 0.6.1: Use NVIC::mask

Disables interrupt

Source

pub fn enable(&mut self, interrupt: I)
where I: Nr,

👎Deprecated since 0.6.1: Use NVIC::unmask

WARNING This method is a soundness hole in the API; it should actually be an unsafe function. Use NVIC::unmask which has the right unsafety.

Source

pub fn get_priority(interrupt: I) -> u8
where I: Nr,

Returns the NVIC priority of interrupt

NOTE NVIC encodes priority in the highest bits of a byte so values like 1 and 2 map to the same priority. Also for NVIC priorities, a lower value (e.g. 16) has higher priority (urgency) than a larger value (e.g. 32).

Source

pub fn is_active(interrupt: I) -> bool
where I: Nr,

Is interrupt active or pre-empted and stacked

Source

pub fn is_enabled(interrupt: I) -> bool
where I: Nr,

Checks if interrupt is enabled

Source

pub fn is_pending(interrupt: I) -> bool
where I: Nr,

Checks if interrupt is pending

Source

pub fn pend(interrupt: I)
where I: Nr,

Forces interrupt into pending state

Source

pub fn set_pending(&mut self, interrupt: I)
where I: Nr,

👎Deprecated since 0.5.8: Use NVIC::pend

Forces interrupt into pending state

Source

pub unsafe fn set_priority(&mut self, interrupt: I, prio: u8)
where I: Nr,

Sets the “priority” of interrupt to prio

NOTE See get_priority method for an explanation of how NVIC priorities work.

On ARMv6-M, updating an interrupt priority requires a read-modify-write operation. On ARMv7-M, the operation is performed in a single atomic write operation.