Struct stm32_hal2::pac::rtc::shiftr::W

pub struct W(_);

Register SHIFTR writer

Implementations

impl W

pub fn subfs(
&mut self
) -> FieldWriterRaw<'_, u32, SHIFTR_SPEC, u16, u16, Safe, 15, 0>

Bits 0:14 - Subtract a fraction of a second These bits are write only and is always read as zero. Writing to this bit has no effect when a shift operation is pending (when SHPF=1, in RTC_ISR). The value which is written to SUBFS is added to the synchronous prescaler counter. Since this counter counts down, this operation effectively subtracts from (delays) the clock by: Delay (seconds) = SUBFS / (PREDIV_S + 1) A fraction of a second can effectively be added to the clock (advancing the clock) when the ADD1S function is used in conjunction with SUBFS, effectively advancing the clock by: Advance (seconds) = (1 - (SUBFS / (PREDIV_S + 1))). Note: Writing to SUBFS causes RSF to be cleared. Software can then wait until RSF=1 to be sure that the shadow registers have been updated with the shifted time.

pub fn add1s(
&mut self
) -> BitWriterRaw<'_, u32, SHIFTR_SPEC, ADD1S_AW, BitM, 31>

Bit 31 - Add one second This bit is write only and is always read as zero. Writing to this bit has no effect when a shift operation is pending (when SHPF=1, in RTC_ISR). This function is intended to be used with SUBFS (see description below) in order to effectively add a fraction of a second to the clock in an atomic operation.

pub unsafe fn bits(&mut self, bits: u32) -> &mut W

Writes raw bits to the register.

Methods from Deref<Target = W<SHIFTR_SPEC>>

pub unsafe fn bits(&mut self, bits: <REG as RegisterSpec>::Ux) -> &mut W<REG>

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<SHIFTR_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<W as Deref>::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut <W as Deref>::Target

Mutably dereferences the value.

impl From<W<SHIFTR_SPEC>> for W

fn from(writer: W<SHIFTR_SPEC>) -> W

Converts to this type from the input type.