Struct stm32_hal2::pac::pwr::cr2::W

pub struct W(_);

Register CR2 writer

Implementations

impl W

pub fn bren(&mut self) -> BitWriterRaw<'_, u32, CR2_SPEC, bool, BitM, 0>

Bit 0 - Backup regulator enable When set, the Backup regulator (used to maintain the backup RAM content in Standby and VBAT modes) is enabled. If BREN is reset, the backup regulator is switched off. The backup RAM can still be used in Run and Stop modes. However, its content will be lost in Standby and VBAT modes. If BREN is set, the application must wait till the Backup Regulator Ready flag (BRRDY) is set to indicate that the data written into the SRAM will be maintained in Standby and VBAT modes.

pub fn monen(&mut self) -> BitWriterRaw<'_, u32, CR2_SPEC, bool, BitM, 4>

Bit 4 - VBAT and temperature monitoring enable When set, the VBAT supply and temperature monitoring is enabled.

pub unsafe fn bits(&mut self, bits: u32) -> &mut W

Writes raw bits to the register.

Methods from Deref<Target = W<CR2_SPEC>>

pub unsafe fn bits(&mut self, bits: <REG as RegisterSpec>::Ux) -> &mut W<REG>

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<CR2_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<W as Deref>::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut <W as Deref>::Target

Mutably dereferences the value.

impl From<W<CR2_SPEC>> for W

fn from(writer: W<CR2_SPEC>) -> W

Converts to this type from the input type.