Struct sounding_analysis::experimental::fire::BlowUpAnalysis [−][src]
This characterizes how much heating it would take to cause a plume to “blow up”.
The blow up ΔT is the difference in temperature from the parcel that blows up to the parcel the analysis started with (usually the mixed layer parcel). The blow up height is the difference in the level of max integrated buoyancy of the blow up ΔT plus 0.05C and the blow up ΔT minus 0.05C. The level of max integrated buoyancy is also an equilibrium level (EL). Usually, but not always, there is only a single EL which corresponds to the level of max integrated buoyancy. So the level of max integrated buoyancy will be referred to as the EL, and in cases where there is multiple ELs, it will be the one that corresponds to the max integrated buoyancy.
The ΔT required to get the plume top over the LCL, and thus to create a cloud is also calculated. This can be a useful for determining if a plume will have a cap cloud but will not be unstable enough to blow up.
After blow up of the equilibrium level, the maximum integrated buoyancy and the percentage of it that is due to latent heat release are also recorded.
Fields
starting_parcel: Parcel
The original parcel we started with while searching for the blow up.
delta_t_el: CelsiusDiff
The amount of warming required to cause a blow up of the level of maximum integrated buoyancy, or the equilibrium level.
delta_t_cloud: CelsiusDiff
The amount of warming required to cause a cloud to form.
delta_z_el: Meters
The change in height from the blow up of the equilbrium level.
mib: JpKg
The maximum integrated buoyancy after blow up.
pct_wet: f64
The percentage of the mib
that is due to latent heat release at delta_t_el
+ 1.0C
Trait Implementations
Auto Trait Implementations
impl RefUnwindSafe for BlowUpAnalysis
impl Send for BlowUpAnalysis
impl Sync for BlowUpAnalysis
impl Unpin for BlowUpAnalysis
impl UnwindSafe for BlowUpAnalysis
Blanket Implementations
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
pub fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> From<T> for T
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
pub fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,