[−][src]Enum rppal::spi::SlaveSelect
Slave Select pins.
Slave Select is used to signal which slave device should pay attention to
the SPI bus. Slave Select (SS) is the more commonly used name, but
it's also known as Chip Select (CS) or Chip Enable (CE). Throughout the Raspberry
Pi's documentation, config files and BCM2835 datasheet, multiple different names
are used. Any pins referred to as CE0, CE1, and CE2 or CS0, CS1, and CS2 are equivalent
to Ss0
, Ss1
, and Ss2
.
The number of available Slave Select pins for the selected SPI bus depends
on your /boot/config.txt
configuration. More information can be found
here.
Variants
Ss0
Ss1
Ss2
Trait Implementations
impl PartialEq<SlaveSelect> for SlaveSelect
[src]
fn eq(&self, other: &SlaveSelect) -> bool
[src]
#[must_use]
fn ne(&self, other: &Rhs) -> bool
1.0.0[src]
#[must_use]
fn ne(&self, other: &Rhs) -> boolThis method tests for !=
.
impl Clone for SlaveSelect
[src]
fn clone(&self) -> SlaveSelect
[src]
fn clone_from(&mut self, source: &Self)
1.0.0[src]
Performs copy-assignment from source
. Read more
impl Copy for SlaveSelect
[src]
impl Debug for SlaveSelect
[src]
Auto Trait Implementations
impl Send for SlaveSelect
impl Sync for SlaveSelect
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> ToOwned for T where
T: Clone,
[src]
T: Clone,
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = !
🔬 This is a nightly-only experimental API. (
try_from
)The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,