[−][src]Struct nrf52810_hal::gpio::Pin
Generic $PX pin
Fields
pin: u8
Methods
impl<MODE> Pin<MODE>
[src]
pub fn into_floating_input(self) -> Pin<Input<Floating>>
[src]
Convert the pin to be a floating input
pub fn into_pullup_input(self) -> Pin<Input<PullUp>>
[src]
pub fn into_pulldown_input(self) -> Pin<Input<PullDown>>
[src]
pub fn into_push_pull_output(
self,
initial_output: Level
) -> Pin<Output<PushPull>>
[src]
self,
initial_output: Level
) -> Pin<Output<PushPull>>
Convert the pin to be a push-pull output with normal drive
pub fn into_open_drain_output(
self,
config: OpenDrainConfig,
initial_output: Level
) -> Pin<Output<OpenDrain>>
[src]
self,
config: OpenDrainConfig,
initial_output: Level
) -> Pin<Output<OpenDrain>>
Convert the pin to be an open-drain output
This method currently does not support configuring an internal pull-up or pull-down resistor.
Trait Implementations
impl<MODE> StatefulOutputPin for Pin<Output<MODE>>
[src]
fn is_set_high(&self) -> bool
[src]
Is the output pin set as high?
fn is_set_low(&self) -> bool
[src]
Is the output pin set as low?
impl<MODE> InputPin for Pin<Input<MODE>>
[src]
impl<MODE> OutputPin for Pin<Output<MODE>>
[src]
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self