Enum StartWorkflowExecutionError

pub enum StartWorkflowExecutionError {
    DefaultUndefinedFault(String),
    LimitExceededFault(String),
    OperationNotPermittedFault(String),
    TypeDeprecatedFault(String),
    UnknownResourceFault(String),
    WorkflowExecutionAlreadyStartedFault(String),
}

Errors returned by StartWorkflowExecution

Variants

DefaultUndefinedFault(String)

The StartWorkflowExecution API action was called without the required parameters set.

Some workflow execution parameters, such as the decision taskList, must be set to start the execution. However, these parameters might have been set as defaults when the workflow type was registered. In this case, you can omit these parameters from the StartWorkflowExecution call and Amazon SWF uses the values defined in the workflow type.

If these parameters aren't set and no default parameters were defined in the workflow type, this error is displayed.

LimitExceededFault(String)

Returned by any operation if a system imposed limitation has been reached. To address this fault you should either clean up unused resources or increase the limit by contacting AWS.

OperationNotPermittedFault(String)

Returned when the caller doesn't have sufficient permissions to invoke the action.

TypeDeprecatedFault(String)

Returned when the specified activity or workflow type was already deprecated.

UnknownResourceFault(String)

Returned when the named resource cannot be found with in the scope of this operation (region or domain). This could happen if the named resource was never created or is no longer available for this operation.

WorkflowExecutionAlreadyStartedFault(String)

Returned by StartWorkflowExecution when an open execution with the same workflowId is already running in the specified domain.

Implementations

impl StartWorkflowExecutionError

pub fn from_response( res: BufferedHttpResponse, ) -> RusotoError<StartWorkflowExecutionError>

Trait Implementations

impl Debug for StartWorkflowExecutionError

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Display for StartWorkflowExecutionError

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Error for StartWorkflowExecutionError

fn source(&self) -> Option<&(dyn Error + 'static)>

Returns the lower-level source of this error, if any.

fn description(&self) -> &str

👎Deprecated since 1.42.0: use the Display impl or to_string()

fn cause(&self) -> Option<&dyn Error>

👎Deprecated since 1.33.0: replaced by Error::source, which can support downcasting

fn provide<'a>(&'a self, request: &mut Request<'a>)

🔬This is a nightly-only experimental API. (error_generic_member_access)

Provides type-based access to context intended for error reports.

impl PartialEq for StartWorkflowExecutionError

fn eq(&self, other: &StartWorkflowExecutionError) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl StructuralPartialEq for StartWorkflowExecutionError