Struct DeviceV2ipSink 

pub struct DeviceV2ipSink {
    pub addresses: V2ipStreamSources,
    pub audio_fmt: Option<V2ipAudioFormat>,
}

The sink-side route a V2IP device is subscribed to, as the mesh believes it.

A route request addressed to the device sets this the moment it is seen, which is what every device on the mesh does with one. So a request the device refused, or that reached it while it was offline, reads back here as though it had taken effect. Only the device’s own configuration report confirms a route, and it sends that on its own schedule rather than in reply.

Addresses that read as unset mean “no route, or the sink could not work one out” - never “definitely not subscribed”. This block is the one part of a device configuration with no validity marker of its own, so a sender with nothing to say sends zeros and every receiver stores them. A sender leaves it empty when its own stream configuration does not resolve, and that covers more than having no route: a selected source whose record has not arrived yet, which is the state after a restart at either end, missing audio bay configuration, or any of the three streams failing its validity check. The audio format has a second gate of its own, so it can be absent while the addresses are not.

This is worth expecting rather than guarding against. Any scaling change makes the device rebuild and rebroadcast this block, and a write aimed at a remote bay sends it zeroed however it was requested - so the empty reading arrives most often during exactly the no-signal troubleshooting that prompted the change. A device’s periodic report puts a real route back within a minute of it having one.

An empty reading is applied rather than ignored on purpose. A sink that has genuinely dropped its route sends the same zeros, and so does every report after it, so refusing them would cache a route that nothing later could ever clear.

Fields

addresses: V2ipStreamSources

The streams the sink subscribes to.

audio_fmt: Option<V2ipAudioFormat>

The resolved audio format, when the sender reported one.

Trait Implementations

impl Clone for DeviceV2ipSink

fn clone(&self) -> DeviceV2ipSink

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Copy for DeviceV2ipSink

impl Debug for DeviceV2ipSink

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for DeviceV2ipSink

fn default() -> DeviceV2ipSink

Returns the “default value” for a type.

impl Eq for DeviceV2ipSink

impl PartialEq for DeviceV2ipSink

fn eq(&self, other: &DeviceV2ipSink) -> bool

Equality operator ==.

fn ne(&self, other: &Rhs) -> bool

Inequality operator !=.

impl StructuralPartialEq for DeviceV2ipSink