Enum mpu9250::GyroTempDataRateConfig [−][src]
pub enum GyroTempDataRateConfig { FChoice0, FChoice1, DlpfConf(Dlpf), }
Controls the gyroscope and temperature sensor data rates and bandwidth.
Can be either set to one of two FChoices, or to one of the 8
digital low pass filter modes. If the DLPF mode is used rate and bandwith
can be further tweaked by Sample Rate Divisor.
See page 13 of [Register map
] for details.
Default is dlpf with default dlpf mode.
Variants
FChoice0
FChoice x0: Gyroscope bandwidth=8800Hz, delay=0.064ms, Fs=32kHz; Temperature sensor bandwidth=4000Hz, delay=0.04ms.
FChoice1
FChoice 01: Gyroscope bandwidth=3600Hz, delay=0.11ms, Fs=32kHz; Temperature sensor bandwidth=4000Hz, delay=0.04ms.
DlpfConf(Dlpf)
FChoice set to 11 and data rate and bandwidth are controlled by Dlpf.
Trait Implementations
impl Copy for GyroTempDataRateConfig
[src]
impl Copy for GyroTempDataRateConfig
impl Clone for GyroTempDataRateConfig
[src]
impl Clone for GyroTempDataRateConfig
fn clone(&self) -> GyroTempDataRateConfig
[src]
fn clone(&self) -> GyroTempDataRateConfig
Returns a copy of the value. Read more
fn clone_from(&mut self, source: &Self)
1.0.0[src]
fn clone_from(&mut self, source: &Self)
Performs copy-assignment from source
. Read more
impl Debug for GyroTempDataRateConfig
[src]
impl Debug for GyroTempDataRateConfig
fn fmt(&self, f: &mut Formatter) -> Result
[src]
fn fmt(&self, f: &mut Formatter) -> Result
Formats the value using the given formatter. Read more
impl Default for GyroTempDataRateConfig
[src]
impl Default for GyroTempDataRateConfig
Auto Trait Implementations
impl Send for GyroTempDataRateConfig
impl Send for GyroTempDataRateConfig
impl Sync for GyroTempDataRateConfig
impl Sync for GyroTempDataRateConfig