Struct P1_01

pub struct P1_01<MODE> { /* private fields */ }

Implementations

impl<MODE> P1_01<MODE>

pub fn into_floating_input(self) -> P1_01<Input<Floating>>

Convert the pin to be a floating input

pub fn into_pulldown_input(self) -> P1_01<Input<PullDown>>

pub fn into_pullup_input(self) -> P1_01<Input<PullUp>>

pub fn into_push_pull_output_drive( self, initial_output: Level, drive: DriveConfig, ) -> P1_01<Output<PushPull>>

Convert the pin to bepin a push-pull output with specified drive

pub fn into_push_pull_output( self, initial_output: Level, ) -> P1_01<Output<PushPull>>

Convert the pin to bepin a push-pull output with normal drive

pub fn into_open_drain_output( self, config: OpenDrainConfig, initial_output: Level, ) -> P1_01<Output<OpenDrain>>

Convert the pin to be an open-drain output

This method currently does not support configuring an internal pull-up or pull-down resistor.

pub fn into_open_drain_input_output( self, config: OpenDrainConfig, initial_output: Level, ) -> P1_01<Output<OpenDrainIO>>

Convert the pin to be an open-drain input/output

Similar to into_open_drain_output, but can also be read from.

This method currently does not support configuring an internal pull-up or pull-down resistor.

pub fn into_disconnected(self) -> P1_01<Disconnected>

Disconnects the pin.

In disconnected mode the pin cannot be used as input or output. It is primarily useful to reduce power usage.

pub fn degrade(self) -> Pin<MODE>

Degrade to a generic pin struct, which can be used with peripherals

Trait Implementations

impl<MODE> ErrorType for P1_01<MODE>

type Error = Infallible

Error type

impl<MODE> From<P1_01<MODE>> for Pin<MODE>

fn from(value: P1_01<MODE>) -> Pin<MODE>

Converts to this type from the input type.

impl<MODE> InputPin for P1_01<Input<MODE>>

fn is_high(&mut self) -> Result<bool, <P1_01<Input<MODE>> as ErrorType>::Error>

Is the input pin high?

fn is_low(&mut self) -> Result<bool, <P1_01<Input<MODE>> as ErrorType>::Error>

Is the input pin low?

impl InputPin for P1_01<Output<OpenDrainIO>>

fn is_high( &mut self, ) -> Result<bool, <P1_01<Output<OpenDrainIO>> as ErrorType>::Error>

Is the input pin high?

fn is_low( &mut self, ) -> Result<bool, <P1_01<Output<OpenDrainIO>> as ErrorType>::Error>

Is the input pin low?

impl<MODE> OutputPin for P1_01<Output<MODE>>

fn set_high(&mut self) -> Result<(), <P1_01<Output<MODE>> as ErrorType>::Error>

Drives the pin high.

fn set_low(&mut self) -> Result<(), <P1_01<Output<MODE>> as ErrorType>::Error>

Drives the pin low.

fn set_state(&mut self, state: PinState) -> Result<(), Self::Error>

Drives the pin high or low depending on the provided value.

impl<MODE> StatefulOutputPin for P1_01<Output<MODE>>

fn is_set_high( &mut self, ) -> Result<bool, <P1_01<Output<MODE>> as ErrorType>::Error>

Is the pin in drive high mode?

fn is_set_low( &mut self, ) -> Result<bool, <P1_01<Output<MODE>> as ErrorType>::Error>

Is the pin in drive low mode?

fn toggle(&mut self) -> Result<(), Self::Error>

Toggle pin output.