Enum Compmode 

pub enum Compmode {
    EqualTo = 0,
    EqualToOrGreaterThan = 1,
}

Compare Mode

Value on reset: 0

Variants

EqualTo = 0

0: The VAL* registers and the PWM counter are compared using an “equal to” method. This means that PWM edges are only produced when the counter is equal to one of the VAL* register values. This implies that a PWM_A output that is high at the end of a period maintains this state until a match with VAL3 clears the output in the following period.

EqualToOrGreaterThan = 1

1: The VAL* registers and the PWM counter are compared using an “equal to or greater than” method. This means that PWM edges are produced when the counter is equal to or greater than one of the VAL* register values. This implies that a PWM_A output that is high at the end of a period could go low at the start of the next period if the starting counter value is greater than (but not necessarily equal to) the new VAL3 value.

Trait Implementations

impl Clone for Compmode

fn clone(&self) -> Compmode

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for Compmode

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<Compmode> for bool

fn from(variant: Compmode) -> Self

Converts to this type from the input type.

impl PartialEq for Compmode

fn eq(&self, other: &Compmode) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Compmode

impl Eq for Compmode

impl StructuralPartialEq for Compmode