Struct W 

pub struct W(/* private fields */);

Register CTRL writer

Implementations

impl W

pub fn enable(&mut self) -> ENABLE_W<'_>

Bit 0 - UART enabled, to enable UART block, it is used to drive a gated clock in order to save power consumption when UART is not used. FIFOs are flushed when UART is disabled.

pub fn parity_en(&mut self) -> PARITY_EN_W<'_>

Bit 1 - Enable/disable Parity bit (9th character).

pub fn parity(&mut self) -> PARITY_W<'_>

Bits 2:3 - When PARITY_EN=1, selects odd, even, Mark or Space parity. Mark parity = always 1; Space parity = always 0.

pub fn parmd(&mut self) -> PARMD_W<'_>

Bit 4 - Selects parity based on 1s or 0s count (when PARITY_EN=1).

pub fn tx_flush(&mut self) -> TX_FLUSH_W<'_>

Bit 5 - Flushes the TX FIFO buffer.

pub fn rx_flush(&mut self) -> RX_FLUSH_W<'_>

Bit 6 - Flushes the RX FIFO buffer.

pub fn bitacc(&mut self) -> BITACC_W<'_>

Bit 7 - If set, bit accuracy is selected, in this case the bit duration is the same for all the bits with the optimal accuracy. But the frame duration can have a significant deviation from the expected baudrate.If clear, frame accuracy is selected, therefore bits can have different duration in order to guarantee the minimum frame deviation.

pub fn char_size(&mut self) -> CHAR_SIZE_W<'_>

Bits 8:9 - Selects UART character size.

pub fn stopbits(&mut self) -> STOPBITS_W<'_>

Bit 10 - Selects the number of stop bits that will be generated.

pub fn flow_ctrl(&mut self) -> FLOW_CTRL_W<'_>

Bit 11 - Enables/disables hardware flow control.

pub fn flow_pol(&mut self) -> FLOW_POL_W<'_>

Bit 12 - RTS/CTS polarity.

pub fn null_modem(&mut self) -> NULL_MODEM_W<'_>

Bit 13 - NULL Modem Support (RTS/CTS and TXD/RXD swap).

pub fn break_(&mut self) -> BREAK_W<'_>

Bit 14 - Break control bit. It causes a break condition to be transmitted to receiving UART.

pub fn clksel(&mut self) -> CLKSEL_W<'_>

Bit 15 - Baud Rate Clock Source Select. Selects the baud rate clock.

pub fn rx_to(&mut self) -> RX_TO_W<'_>

Bits 16:23 - RX Time Out. RX time out interrupt will occur after RXTO Uart characters if RX-FIFO is not empty and RX FIFO has not been read.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<CTRL_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<CTRL_SPEC>> for W

fn from(writer: W<CTRL_SPEC>) -> Self

Converts to this type from the input type.