Struct R 

pub struct R(/* private fields */);

Register CTRL reader

Implementations

impl R

pub fn enable(&self) -> ENABLE_R

Bit 0 - UART enabled, to enable UART block, it is used to drive a gated clock in order to save power consumption when UART is not used. FIFOs are flushed when UART is disabled.

pub fn parity_en(&self) -> PARITY_EN_R

Bit 1 - Enable/disable Parity bit (9th character).

pub fn parity(&self) -> PARITY_R

Bits 2:3 - When PARITY_EN=1, selects odd, even, Mark or Space parity. Mark parity = always 1; Space parity = always 0.

pub fn parmd(&self) -> PARMD_R

Bit 4 - Selects parity based on 1s or 0s count (when PARITY_EN=1).

pub fn tx_flush(&self) -> TX_FLUSH_R

Bit 5 - Flushes the TX FIFO buffer.

pub fn rx_flush(&self) -> RX_FLUSH_R

Bit 6 - Flushes the RX FIFO buffer.

pub fn bitacc(&self) -> BITACC_R

Bit 7 - If set, bit accuracy is selected, in this case the bit duration is the same for all the bits with the optimal accuracy. But the frame duration can have a significant deviation from the expected baudrate.If clear, frame accuracy is selected, therefore bits can have different duration in order to guarantee the minimum frame deviation.

pub fn char_size(&self) -> CHAR_SIZE_R

Bits 8:9 - Selects UART character size.

pub fn stopbits(&self) -> STOPBITS_R

Bit 10 - Selects the number of stop bits that will be generated.

pub fn flow_ctrl(&self) -> FLOW_CTRL_R

Bit 11 - Enables/disables hardware flow control.

pub fn flow_pol(&self) -> FLOW_POL_R

Bit 12 - RTS/CTS polarity.

pub fn null_modem(&self) -> NULL_MODEM_R

Bit 13 - NULL Modem Support (RTS/CTS and TXD/RXD swap).

pub fn break_(&self) -> BREAK_R

Bit 14 - Break control bit. It causes a break condition to be transmitted to receiving UART.

pub fn clksel(&self) -> CLKSEL_R

Bit 15 - Baud Rate Clock Source Select. Selects the baud rate clock.

pub fn rx_to(&self) -> RX_TO_R

Bits 16:23 - RX Time Out. RX time out interrupt will occur after RXTO Uart characters if RX-FIFO is not empty and RX FIFO has not been read.

Methods from Deref<Target = R<CTRL_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CTRL_SPEC>> for R

fn from(reader: R<CTRL_SPEC>) -> Self

Converts to this type from the input type.