Struct W 

pub struct W(/* private fields */);

Register CTRL writer

Implementations

impl W

pub fn rtce(&mut self) -> RTCE_W<'_>

Bit 0 - Real Time Clock Enable. This bit enables the Real Time Clock. This bit can only be written when WE=1 and BUSY =0. Change to this bit is effective only after BUSY is cleared from 1 to 0.

pub fn ade(&mut self) -> ADE_W<'_>

Bit 1 - Alarm Time-of-Day Interrupt Enable. Change to this bit is effective only after BUSY is cleared from 1 to 0.

pub fn ase(&mut self) -> ASE_W<'_>

Bit 2 - Alarm Sub-second Interrupt Enable. Change to this bit is effective only after BUSY is cleared from 1 to 0.

pub fn rdy(&mut self) -> RDY_W<'_>

Bit 4 - RTC Ready. This bit is set to 1 by hardware when the RTC count registers update. It can be cleared to 0 by software at any time. It will also be cleared to 0 by hardware just prior to an update of the RTC count register.

pub fn rdye(&mut self) -> RDYE_W<'_>

Bit 5 - RTC Ready Interrupt Enable.

pub fn sqe(&mut self) -> SQE_W<'_>

Bit 8 - Square Wave Output Enable.

pub fn ft(&mut self) -> FT_W<'_>

Bits 9:10 - Frequency Output Selection. When SQE=1, these bits specify the output frequency on the SQW pin.

pub fn x32kmd(&mut self) -> X32KMD_W<'_>

Bits 11:12 - 32KHz Oscillator Mode.

pub fn we(&mut self) -> WE_W<'_>

Bit 15 - Write Enable. This register bit serves as a protection mechanism against unintentional writes to critical RTC bits.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<CTRL_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<CTRL_SPEC>> for W

fn from(writer: W<CTRL_SPEC>) -> Self

Converts to this type from the input type.