Struct lpc81x_pac::lpc810::usart0::stat::R

pub struct R(_);

Register STAT reader

Implementations

impl R

pub fn rxrdy(&self) -> RXRDY_R

Bit 0 - Receiver Ready flag. When 1, indicates that data is available to be read from the receiver buffer. Cleared after a read of the RXDAT or RXDATSTAT registers.

pub fn rxidle(&self) -> RXIDLE_R

Bit 1 - Receiver Idle. When 0, indicates that the receiver is currently in the process of receiving data. When 1, indicates that the receiver is not currently in the process of receiving data.

pub fn txrdy(&self) -> TXRDY_R

Bit 2 - Transmitter Ready flag. When 1, this bit indicates that data may be written to the transmit buffer. Previous data may still be in the process of being transmitted. Cleared when data is written to TXDAT. Set when the data is moved from the transmit buffer to the transmit shift register.

pub fn txidle(&self) -> TXIDLE_R

Bit 3 - Transmitter Idle. When 0, indicates that the transmitter is currently in the process of sending data.When 1, indicate that the transmitter is not currently in the process of sending data.

pub fn cts(&self) -> CTS_R

Bit 4 - This bit reflects the current state of the CTS signal, regardless of the setting of the CTSEN bit in the CFG register. This will be the value of the CTS input pin unless loopback mode is enabled.

pub fn txdisstat(&self) -> TXDISSTAT_R

Bit 6 - Transmitter Disabled Interrupt flag. When 1, this bit indicates that the USART transmitter is fully idle after being disabled via the TXDIS in the CTL register (TXDIS = 1).

pub fn rxbrk(&self) -> RXBRK_R

Bit 10 - Received Break. This bit reflects the current state of the receiver break detection logic. It is set when the Un_RXD pin remains low for 16 bit times. Note that FRAMERRINT will also be set when this condition occurs because the stop bit(s) for the character would be missing. RXBRK is cleared when the Un_RXD pin goes high.

Methods from Deref<Target = R<STAT_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<STAT_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<STAT_SPEC>> for R

fn from(reader: R<STAT_SPEC>) -> Self

Converts to this type from the input type.