[−][src]Type Definition lpc55s6x_pac::usbphy::usb1_vbus_detect_tog::W
type W = W<u32, USB1_VBUS_DETECT_TOG>;
Writer for register USB1_VBUS_DETECT_TOG
Methods
impl W
[src]
pub fn vbusvalid_thresh(&mut self) -> VBUSVALID_THRESH_W
[src]
Bits 0:2 - Sets the threshold for the VBUSVALID comparator
pub fn vbus_override_en(&mut self) -> VBUS_OVERRIDE_EN_W
[src]
Bit 3 - VBUS detect signal override enable
pub fn sessend_override(&mut self) -> SESSEND_OVERRIDE_W
[src]
Bit 4 - Override value for SESSEND The bit field provides the value for USB1_VBUS_DET_STAT[0] if USB_VBUS_DETECT[3] is set to value 1'b1
pub fn bvalid_override(&mut self) -> BVALID_OVERRIDE_W
[src]
Bit 5 - Override value for B-Device Session Valid The bit field provides the value for USB1_VBUS_DET_STAT[1] if USB_VBUS_DETECT[3] is set to value 1'b1
pub fn avalid_override(&mut self) -> AVALID_OVERRIDE_W
[src]
Bit 6 - Override value for A-Device Session Valid The bit field provides the value for USB1_VBUS_DET_STAT[2] if USB_VBUS_DETECT[3] is set to value 1'b1
pub fn vbusvalid_override(&mut self) -> VBUSVALID_OVERRIDE_W
[src]
Bit 7 - Override value for VBUS_VALID signal sent to USB controller The bit field provides the value for VBUS_VALID reported to the USB controller if the value of USB1_VBUS_DETECT[3] is set to 1'b1
pub fn vbusvalid_sel(&mut self) -> VBUSVALID_SEL_W
[src]
Bit 8 - Selects the source of the VBUS_VALID signal reported to the USB controller This is one of the bit fields that selects the source of the VBUS_VALID signal reported to the USB controller
pub fn vbus_source_sel(&mut self) -> VBUS_SOURCE_SEL_W
[src]
Bits 9:10 - Selects the source of the VBUS_VALID signal reported to the USB controller This is one of the bit fields that selects the source of the VBUS_VALID signal reported to the USB controller
pub fn vbusvalid_to_sessvalid(&mut self) -> VBUSVALID_TO_SESSVALID_W
[src]
Bit 18 - Selects the comparator used for VBUS_VALID This bit field controls the comparator used to report the VBUS_VALID results in USB1_VBUS_DETECT[3] between the VBUS_VALID comparator and the Session Valid comparator
pub fn pwrup_cmps(&mut self) -> PWRUP_CMPS_W
[src]
Bit 20 - Enables the VBUS_VALID comparator Powers up the comparator used for the VBUS_VALID detector
pub fn discharge_vbus(&mut self) -> DISCHARGE_VBUS_W
[src]
Bit 26 - Controls VBUS discharge resistor This bit field controls a nominal 22kohm resistor between the USB1_VBUS pin and ground
pub fn en_charger_resistor(&mut self) -> EN_CHARGER_RESISTOR_W
[src]
Bit 31 - Enables resistors used for an older method of resistive battery charger detection