[−][src]Type Definition lpc55s6x_pac::usbfsh::hcrhportstatus::R
type R = R<u32, HCRHPORTSTATUS>;
Reader of register HCRHPORTSTATUS
Methods
impl R
[src]
pub fn ccs(&self) -> CCS_R
[src]
Bit 0 - (read) CurrentConnectStatus This bit reflects the current state of the downstream port.
pub fn pes(&self) -> PES_R
[src]
Bit 1 - (read) PortEnableStatus This bit indicates whether the port is enabled or disabled.
pub fn pss(&self) -> PSS_R
[src]
Bit 2 - (read) PortSuspendStatus This bit indicates the port is suspended or in the resume sequence.
pub fn poci(&self) -> POCI_R
[src]
Bit 3 - (read) PortOverCurrentIndicator This bit is only valid when the Root Hub is configured in such a way that overcurrent conditions are reported on a per-port basis.
pub fn prs(&self) -> PRS_R
[src]
Bit 4 - (read) PortResetStatus When this bit is set by a write to SetPortReset, port reset signaling is asserted.
pub fn pps(&self) -> PPS_R
[src]
Bit 8 - (read) PortPowerStatus This bit reflects the porta's power status, regardless of the type of power switching implemented.
pub fn lsda(&self) -> LSDA_R
[src]
Bit 9 - (read) LowSpeedDeviceAttached This bit indicates the speed of the device attached to this port.
pub fn csc(&self) -> CSC_R
[src]
Bit 16 - ConnectStatusChange This bit is set whenever a connect or disconnect event occurs.
pub fn pesc(&self) -> PESC_R
[src]
Bit 17 - PortEnableStatusChange This bit is set when hardware events cause the PortEnableStatus bit to be cleared.
pub fn pssc(&self) -> PSSC_R
[src]
Bit 18 - PortSuspendStatusChange This bit is set when the full resume sequence is completed.
pub fn ocic(&self) -> OCIC_R
[src]
Bit 19 - PortOverCurrentIndicatorChange This bit is valid only if overcurrent conditions are reported on a per-port basis.
pub fn prsc(&self) -> PRSC_R
[src]
Bit 20 - PortResetStatusChange This bit is set at the end of the 10 ms port reset signal.