[−][src]Type Definition lpc55s6x_pac::usbphy::debug0::W
type W = W<u32, DEBUG0>;
Writer for register DEBUG0
Methods
impl W
[src]
pub fn otgidpiolock(&mut self) -> OTGIDPIOLOCK_W
[src]
Bit 0 - Once OTG ID from STATUS_OTGID_STATUS is sampled, use this to hold the value
pub fn debug_interface_hold(&mut self) -> DEBUG_INTERFACE_HOLD_W
[src]
Bit 1 - Use holding registers to assist in timing for external UTMI interface.
pub fn hstpulldown(&mut self) -> HSTPULLDOWN_W
[src]
Bits 2:3 - This bit field selects whether to connect pulldown resistors on the USB_DP/USB_DM pins if the corresponding pulldown overdrive mode is enabled through DEBUG[5:4} Set bit 3 to value 1'b1 to connect the 15ohm pulldown on USB_DP line
pub fn enhstpulldown(&mut self) -> ENHSTPULLDOWN_W
[src]
Bits 4:5 - This bit field selects host pulldown overdrive mode
pub fn tx2rxcount(&mut self) -> TX2RXCOUNT_W
[src]
Bits 8:11 - Delay in between the end of transmit to the beginning of receive
pub fn entx2rxcount(&mut self) -> ENTX2RXCOUNT_W
[src]
Bit 12 - Set this bit to allow a countdown to transition in between TX and RX.
pub fn squelchresetcount(&mut self) -> SQUELCHRESETCOUNT_W
[src]
Bits 16:20 - Delay in between the detection of squelch to the reset of high-speed RX.
pub fn ensquelchreset(&mut self) -> ENSQUELCHRESET_W
[src]
Bit 24 - Set bit to allow squelch to reset high-speed receive.
pub fn squelchresetlength(&mut self) -> SQUELCHRESETLENGTH_W
[src]
Bits 25:28 - Duration of RESET in terms of the number of 480-MHz cycles.
pub fn host_resume_debug(&mut self) -> HOST_RESUME_DEBUG_W
[src]
Bit 29 - Choose to trigger the host resume SE0 with HOST_FORCE_LS_SE0 = 0 or UTMI_SUSPEND = 1.
pub fn clkgate(&mut self) -> CLKGATE_W
[src]
Bit 30 - Gate Test Clocks