[−][src]Type Definition lpc55s6x_pac::usbhsd::devcmdstat::W
type W = W<u32, DEVCMDSTAT>;
Writer for register DEVCMDSTAT
Methods
impl W
[src]
pub fn dev_addr(&mut self) -> DEV_ADDR_W
[src]
Bits 0:6 - USB device address.
pub fn dev_en(&mut self) -> DEV_EN_W
[src]
Bit 7 - USB device enable.
pub fn setup(&mut self) -> SETUP_W
[src]
Bit 8 - SETUP token received.
pub fn force_needclk(&mut self) -> FORCE_NEEDCLK_W
[src]
Bit 9 - Forces the NEEDCLK output to always be on:.
pub fn force_vbus(&mut self) -> FORCE_VBUS_W
[src]
Bit 10 - If this bit is set to 1, the VBUS voltage indicators from the PHY are overruled.
pub fn lpm_sup(&mut self) -> LPM_SUP_W
[src]
Bit 11 - LPM Supported:.
pub fn intonnak_ao(&mut self) -> INTONNAK_AO_W
[src]
Bit 12 - Interrupt on NAK for interrupt and bulk OUT EP:.
pub fn intonnak_ai(&mut self) -> INTONNAK_AI_W
[src]
Bit 13 - Interrupt on NAK for interrupt and bulk IN EP:.
pub fn intonnak_co(&mut self) -> INTONNAK_CO_W
[src]
Bit 14 - Interrupt on NAK for control OUT EP:.
pub fn intonnak_ci(&mut self) -> INTONNAK_CI_W
[src]
Bit 15 - Interrupt on NAK for control IN EP:.
pub fn dcon(&mut self) -> DCON_W
[src]
Bit 16 - Device status - connect.
pub fn dsus(&mut self) -> DSUS_W
[src]
Bit 17 - Device status - suspend.
pub fn lpm_sus(&mut self) -> LPM_SUS_W
[src]
Bit 19 - Device status - LPM Suspend.
pub fn dcon_c(&mut self) -> DCON_C_W
[src]
Bit 24 - Device status - connect change.
pub fn dsus_c(&mut self) -> DSUS_C_W
[src]
Bit 25 - Device status - suspend change.
pub fn dres_c(&mut self) -> DRES_C_W
[src]
Bit 26 - Device status - reset change.
pub fn phy_test_mode(&mut self) -> PHY_TEST_MODE_W
[src]
Bits 29:31 - This field is written by firmware to put the PHY into a test mode as defined by the USB2.