[−][src]Type Definition imxrt1062_pmu::reg_2p5::R
type R = R<u32, REG_2P5>;
Reader of register REG_2P5
Methods
impl R
[src]
pub fn enable_linreg(&self) -> ENABLE_LINREG_R
[src]
Bit 0 - Control bit to enable the regulator output.
pub fn enable_bo(&self) -> ENABLE_BO_R
[src]
Bit 1 - Control bit to enable the brownout circuitry in the regulator.
pub fn enable_ilimit(&self) -> ENABLE_ILIMIT_R
[src]
Bit 2 - Control bit to enable the current-limit circuitry in the regulator.
pub fn enable_pulldown(&self) -> ENABLE_PULLDOWN_R
[src]
Bit 3 - Control bit to enable the pull-down circuitry in the regulator
pub fn bo_offset(&self) -> BO_OFFSET_R
[src]
Bits 4:6 - Control bits to adjust the regulator brownout offset voltage in 25mV steps
pub fn output_trg(&self) -> OUTPUT_TRG_R
[src]
Bits 8:12 - Control bits to adjust the regulator output voltage
pub fn bo_vdd2p5(&self) -> BO_VDD2P5_R
[src]
Bit 16 - Status bit that signals when a brownout is detected on the regulator output.
pub fn ok_vdd2p5(&self) -> OK_VDD2P5_R
[src]
Bit 17 - Status bit that signals when the regulator output is ok. 1 = regulator output > brownout target
pub fn enable_weak_linreg(&self) -> ENABLE_WEAK_LINREG_R
[src]
Bit 18 - Enables the weak 2p5 regulator