Struct esp32s3::rtcio::pin::R

pub struct R(_);

Register PIN%s reader

Implementations

impl R

pub fn pad_driver(&self) -> PAD_DRIVER_R

Bit 2 - if set to 0: normal output, if set to 1: open drain

pub fn int_type(&self) -> INT_TYPE_R

Bits 7:9 - if set to 0: GPIO interrupt disable, if set to 1: rising edge trigger, if set to 2: falling edge trigger, if set to 3: any edge trigger, if set to 4: low level trigger, if set to 5: high level trigger

pub fn wakeup_enable(&self) -> WAKEUP_ENABLE_R

Bit 10 - RTC GPIO wakeup enable bit

Methods from Deref<Target = R<PIN_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<PIN_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<PIN_SPEC>> for R

fn from(reader: R<PIN_SPEC>) -> Self

Converts to this type from the input type.