Struct esp32s3::gpio::pin::W

pub struct W(_);

Register PIN%s writer

Implementations

impl W

pub fn sync2_bypass(&mut self) -> SYNC2_BYPASS_W<'_, 0>

Bits 0:1 - set GPIO input_sync2 signal mode. 0:disable. 1:trigger at negedge. 2or3:trigger at posedge.

pub fn pad_driver(&mut self) -> PAD_DRIVER_W<'_, 2>

Bit 2 - set this bit to select pad driver. 1:open-drain. 0:normal.

pub fn sync1_bypass(&mut self) -> SYNC1_BYPASS_W<'_, 3>

Bits 3:4 - set GPIO input_sync1 signal mode. 0:disable. 1:trigger at negedge. 2or3:trigger at posedge.

pub fn int_type(&mut self) -> INT_TYPE_W<'_, 7>

Bits 7:9 - set this value to choose interrupt mode. 0:disable GPIO interrupt. 1:trigger at posedge. 2:trigger at negedge. 3:trigger at any edge. 4:valid at low level. 5:valid at high level

pub fn wakeup_enable(&mut self) -> WAKEUP_ENABLE_W<'_, 10>

Bit 10 - set this bit to enable GPIO wakeup.(can only wakeup CPU from Light-sleep Mode)

pub fn config(&mut self) -> CONFIG_W<'_, 11>

Bits 11:12 - reserved

pub fn int_ena(&mut self) -> INT_ENA_W<'_, 13>

Bits 13:17 - set bit 13 to enable CPU interrupt. set bit 14 to enable CPU(not shielded) interrupt.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<PIN_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<PIN_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<PIN_SPEC>> for W

fn from(writer: W<PIN_SPEC>) -> Self

Converts to this type from the input type.