Struct esp32s3::spi1::misc::R

pub struct R(_);

Register MISC reader

Implementations

impl R

pub fn cs0_dis(&self) -> CS0_DIS_R

Bit 0 - Set this bit to raise high SPI_CS pin, which means that the SPI device(flash) connected to SPI_CS is in low level when SPI1 transfer starts.

pub fn cs1_dis(&self) -> CS1_DIS_R

Bit 1 - Set this bit to raise high SPI_CS1 pin, which means that the SPI device(Ext_RAM) connected to SPI_CS1 is in low level when SPI1 transfer starts.

pub fn ck_idle_edge(&self) -> CK_IDLE_EDGE_R

Bit 9 - 1: SPI_CLK line is high when MSPI is idle. 0: SPI_CLK line is low when MSPI is idle.

pub fn cs_keep_active(&self) -> CS_KEEP_ACTIVE_R

Bit 10 - SPI_CS line keep low when the bit is set.

pub fn auto_per(&self) -> AUTO_PER_R

Bit 11 - Set this bit to enable auto PER function. Hardware will sent out PER command if PES command is sent.

Methods from Deref<Target = R<MISC_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<MISC_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<MISC_SPEC>> for R

fn from(reader: R<MISC_SPEC>) -> Self

Converts to this type from the input type.