Module esp32s3::gpio::pin

GPIO pin configuration register

Structs

• PIN_SPEC
  GPIO pin configuration register

Type Aliases

• CONFIG_R
  Field CONFIG reader - reserved
• CONFIG_W
  Field CONFIG writer - reserved
• INT_ENA_R
  Field INT_ENA reader - set bit 13 to enable CPU interrupt. set bit 14 to enable CPU(not shielded) interrupt.
• INT_ENA_W
  Field INT_ENA writer - set bit 13 to enable CPU interrupt. set bit 14 to enable CPU(not shielded) interrupt.
• INT_TYPE_R
  Field INT_TYPE reader - set this value to choose interrupt mode. 0:disable GPIO interrupt. 1:trigger at posedge. 2:trigger at negedge. 3:trigger at any edge. 4:valid at low level. 5:valid at high level
• INT_TYPE_W
  Field INT_TYPE writer - set this value to choose interrupt mode. 0:disable GPIO interrupt. 1:trigger at posedge. 2:trigger at negedge. 3:trigger at any edge. 4:valid at low level. 5:valid at high level
• PAD_DRIVER_R
  Field PAD_DRIVER reader - set this bit to select pad driver. 1:open-drain. 0:normal.
• PAD_DRIVER_W
  Field PAD_DRIVER writer - set this bit to select pad driver. 1:open-drain. 0:normal.
• R
  Register PIN%s reader
• SYNC1_BYPASS_R
  Field SYNC1_BYPASS reader - set GPIO input_sync1 signal mode. 0:disable. 1:trigger at negedge. 2or3:trigger at posedge.
• SYNC1_BYPASS_W
  Field SYNC1_BYPASS writer - set GPIO input_sync1 signal mode. 0:disable. 1:trigger at negedge. 2or3:trigger at posedge.
• SYNC2_BYPASS_R
  Field SYNC2_BYPASS reader - set GPIO input_sync2 signal mode. 0:disable. 1:trigger at negedge. 2or3:trigger at posedge.
• SYNC2_BYPASS_W
  Field SYNC2_BYPASS writer - set GPIO input_sync2 signal mode. 0:disable. 1:trigger at negedge. 2or3:trigger at posedge.
• W
  Register PIN%s writer
• WAKEUP_ENABLE_R
  Field WAKEUP_ENABLE reader - set this bit to enable GPIO wakeup.(can only wakeup CPU from Light-sleep Mode)
• WAKEUP_ENABLE_W
  Field WAKEUP_ENABLE writer - set this bit to enable GPIO wakeup.(can only wakeup CPU from Light-sleep Mode)