Struct esp32s3::ledc::ch_conf1::R

pub struct R(_);

Register CH%s_CONF1 reader

Implementations

impl R

pub fn duty_scale(&self) -> DUTY_SCALE_R

Bits 0:9 - This register is used to configure the changing step scale of duty on channel %s.

pub fn duty_cycle(&self) -> DUTY_CYCLE_R

Bits 10:19 - The duty will change every LEDC_DUTY_CYCLE_CH%s on channel %s.

pub fn duty_num(&self) -> DUTY_NUM_R

Bits 20:29 - This register is used to control the number of times the duty cycle will be changed.

pub fn duty_inc(&self) -> DUTY_INC_R

Bit 30 - This register is used to increase or decrease the duty of output signal on channel %s. 1: Increase; 0: Decrease.

pub fn duty_start(&self) -> DUTY_START_R

Bit 31 - Other configured fields in LEDC_CH%s_CONF1_REG will start to take effect when this bit is set to 1.

Methods from Deref<Target = R<CH_CONF1_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CH_CONF1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CH_CONF1_SPEC>> for R

fn from(reader: R<CH_CONF1_SPEC>) -> Self

Converts to this type from the input type.