Struct esp32s3::mcpwm0::fault_detect::R

pub struct R(_);

Register FAULT_DETECT reader

Implementations

impl R

pub fn f0_en(&self) -> F0_EN_R

Bit 0 - When set, event_f0 generation is enabled

pub fn f1_en(&self) -> F1_EN_R

Bit 1 - When set, event_f1 generation is enabled

pub fn f2_en(&self) -> F2_EN_R

Bit 2 - When set, event_f2 generation is enabled

pub fn f0_pole(&self) -> F0_POLE_R

Bit 3 - Set event_f0 trigger polarity on FAULT2 source from GPIO matrix. 0: level low, 1: level high

pub fn f1_pole(&self) -> F1_POLE_R

Bit 4 - Set event_f1 trigger polarity on FAULT2 source from GPIO matrix. 0: level low, 1: level high

pub fn f2_pole(&self) -> F2_POLE_R

Bit 5 - Set event_f2 trigger polarity on FAULT2 source from GPIO matrix. 0: level low, 1: level high

pub fn event_f0(&self) -> EVENT_F0_R

Bit 6 - Set and reset by hardware. If set, event_f0 is on going

pub fn event_f1(&self) -> EVENT_F1_R

Bit 7 - Set and reset by hardware. If set, event_f1 is on going

pub fn event_f2(&self) -> EVENT_F2_R

Bit 8 - Set and reset by hardware. If set, event_f2 is on going

Methods from Deref<Target = R<FAULT_DETECT_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<FAULT_DETECT_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<FAULT_DETECT_SPEC>> for R

fn from(reader: R<FAULT_DETECT_SPEC>) -> Self

Converts to this type from the input type.