Struct esp32s3::mcpwm0::timer2_sync::R

pub struct R(_);

Register TIMER2_SYNC reader

Implementations

impl R

pub fn timer2_synci_en(&self) -> TIMER2_SYNCI_EN_R

Bit 0 - When set, timer reloading with phase on sync input event is enabled.

pub fn sw(&self) -> SW_R

Bit 1 - Toggling this bit will trigger a software sync.

pub fn timer2_synco_sel(&self) -> TIMER2_SYNCO_SEL_R

Bits 2:3 - PWM timer2 sync_out selection, 0: synci, 1: TEZ, 2: TEP, otherwise:sync out is software sync

pub fn timer2_phase(&self) -> TIMER2_PHASE_R

Bits 4:19 - phase for timer reload on sync event

pub fn timer2_phase_direction(&self) -> TIMER2_PHASE_DIRECTION_R

Bit 20 - Configure the PWM timer2’s direction when timer2 mode is up-down mode. 0: increase; 1: decrease.

Methods from Deref<Target = R<TIMER2_SYNC_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<TIMER2_SYNC_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<TIMER2_SYNC_SPEC>> for R

fn from(reader: R<TIMER2_SYNC_SPEC>) -> Self

Converts to this type from the input type.