Struct esp32s3::uart0::rs485_conf::R
source · pub struct R(_);
Expand description
Register RS485_CONF
reader
Implementations§
source§impl R
impl R
sourcepub fn rs485_en(&self) -> RS485_EN_R
pub fn rs485_en(&self) -> RS485_EN_R
Bit 0 - Set this bit to choose the rs485 mode.
sourcepub fn rs485tx_rx_en(&self) -> RS485TX_RX_EN_R
pub fn rs485tx_rx_en(&self) -> RS485TX_RX_EN_R
Bit 3 - Set this bit to enable receiver could receive data when the transmitter is transmitting data in rs485 mode.
sourcepub fn rs485rxby_tx_en(&self) -> RS485RXBY_TX_EN_R
pub fn rs485rxby_tx_en(&self) -> RS485RXBY_TX_EN_R
Bit 4 - 1’h1: enable rs485 transmitter to send data when rs485 receiver line is busy.
sourcepub fn rs485_rx_dly_num(&self) -> RS485_RX_DLY_NUM_R
pub fn rs485_rx_dly_num(&self) -> RS485_RX_DLY_NUM_R
Bit 5 - This register is used to delay the receiver’s internal data signal.
sourcepub fn rs485_tx_dly_num(&self) -> RS485_TX_DLY_NUM_R
pub fn rs485_tx_dly_num(&self) -> RS485_TX_DLY_NUM_R
Bits 6:9 - This register is used to delay the transmitter’s internal data signal.