Struct esp32s3::spi1::user::R

pub struct R(_);

Register USER reader

Implementations

impl R

pub fn ck_out_edge(&self) -> CK_OUT_EDGE_R

Bit 9 - This bit, combined with SPI_MEM_CK_IDLE_EDGE bit, is used to change the clock mode 0~3 of SPI_CLK.

pub fn fwrite_dual(&self) -> FWRITE_DUAL_R

Bit 12 - Set this bit to enable 2-bm in DOUT phase in SPI1 write operation.

pub fn fwrite_quad(&self) -> FWRITE_QUAD_R

Bit 13 - Set this bit to enable 4-bm in DOUT phase in SPI1 write operation.

pub fn fwrite_dio(&self) -> FWRITE_DIO_R

Bit 14 - Set this bit to enable 2-bm in ADDR and DOUT phase in SPI1 write operation.

pub fn fwrite_qio(&self) -> FWRITE_QIO_R

Bit 15 - Set this bit to enable 4-bit-mode(4-bm) in ADDR and DOUT phase in SPI1 write operation.

pub fn usr_miso_highpart(&self) -> USR_MISO_HIGHPART_R

Bit 24 - DIN phase only access to high-part of the buffer SPI_MEM_W8_REG~SPI_MEM_W15_REG. 1: enable 0: disable.

pub fn usr_mosi_highpart(&self) -> USR_MOSI_HIGHPART_R

Bit 25 - DOUT phase only access to high-part of the buffer SPI_MEM_W8_REG~SPI_MEM_W15_REG. 1: enable 0: disable.

pub fn usr_dummy_idle(&self) -> USR_DUMMY_IDLE_R

Bit 26 - SPI_CLK is disabled(No clock edges) in DUMMY phase when the bit is enable.

pub fn usr_mosi(&self) -> USR_MOSI_R

Bit 27 - Set this bit to enable the DOUT phase of an write-data operation.

pub fn usr_miso(&self) -> USR_MISO_R

Bit 28 - Set this bit to enable enable the DIN phase of a read-data operation.

pub fn usr_dummy(&self) -> USR_DUMMY_R

Bit 29 - Set this bit to enable enable the DUMMY phase of an operation.

pub fn usr_addr(&self) -> USR_ADDR_R

Bit 30 - Set this bit to enable enable the ADDR phase of an operation.

pub fn usr_command(&self) -> USR_COMMAND_R

Bit 31 - Set this bit to enable enable the CMD phase of an operation.

Methods from Deref<Target = R<USER_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<USER_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<USER_SPEC>> for R

fn from(reader: R<USER_SPEC>) -> Self

Converts to this type from the input type.