Struct esp32s3::spi0::user::W

pub struct W(_);

Register USER writer

Implementations

impl W

pub fn cs_hold(&mut self) -> CS_HOLD_W<'_, 6>

Bit 6 - Set this bit to keep SPI_CS low when MSPI is in DONE state.

pub fn cs_setup(&mut self) -> CS_SETUP_W<'_, 7>

Bit 7 - Set this bit to keep SPI_CS low when MSPI is in PREP state.

pub fn ck_out_edge(&mut self) -> CK_OUT_EDGE_W<'_, 9>

Bit 9 - This bit, combined with SPI_MEM_CK_IDLE_EDGE bit, is used to change the clock mode 0~3 of SPI_CLK.

pub fn usr_dummy_idle(&mut self) -> USR_DUMMY_IDLE_W<'_, 26>

Bit 26 - SPI_CLK is disabled(No clock edges) in DUMMY phase when the bit is enable.

pub fn usr_dummy(&mut self) -> USR_DUMMY_W<'_, 29>

Bit 29 - This bit enable the DUMMY phase of an SPI transfer.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<USER_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<USER_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<USER_SPEC>> for W

fn from(writer: W<USER_SPEC>) -> Self

Converts to this type from the input type.